Hi all.
I am trying to install a Danfoss Living connect thermostat in to homeseer but i cant get it to update homeseer.
info on the device can be found here: http://www.pepper1.net/zwavedb/device/6
i also get the following error in the log
09/05/2011 22:34:59 Z-Wave Warning !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! 09/05/2011 22:34:59 Z-Wave Warning The climate control schedule command class is not fully supported for the device at node 18. Please contact HomeSeer Technologies. 09/05/2011 22:34:59 Z-Wave Warning !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Then i get the following error
09/05/2011 22:44:23 Warning Aborting Z-Wave send, taking too long to send command to node 18 waited 2 seconds
09/05/2011 22:44:21 Warning Sensor woke up, but queued configuration command encountered an error when sent. Type=ASSOCIATION_SET_HOMESEER, Result=Association Failed - Z-Wave Z-Wave Interface Z-Wave Thermostat 18 does not support Associations.
can anyone help me with this one?
Greig.
I am trying to install a Danfoss Living connect thermostat in to homeseer but i cant get it to update homeseer.
info on the device can be found here: http://www.pepper1.net/zwavedb/device/6
i also get the following error in the log
09/05/2011 22:34:59 Z-Wave Warning !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! 09/05/2011 22:34:59 Z-Wave Warning The climate control schedule command class is not fully supported for the device at node 18. Please contact HomeSeer Technologies. 09/05/2011 22:34:59 Z-Wave Warning !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Then i get the following error
09/05/2011 22:44:23 Warning Aborting Z-Wave send, taking too long to send command to node 18 waited 2 seconds
09/05/2011 22:44:21 Warning Sensor woke up, but queued configuration command encountered an error when sent. Type=ASSOCIATION_SET_HOMESEER, Result=Association Failed - Z-Wave Z-Wave Interface Z-Wave Thermostat 18 does not support Associations.
can anyone help me with this one?
Greig.
Comment