Was going to give Blade's Ninja control plugin a test spin, untill I discovered that his CM19 driver only worked under Windows 7 23-bit...unfortunately, my system is 64-bit, and I REALLY don't want to reformat and reinstall the 32-bit version.
That being said, the CM15 USB interface DOES transmit signals to the pan & tilt cameras.....however, only through the remote control...but does that not indicate that the CM15 is capable of accepting variables and sending them on the the pan & tilts ? ( Oh, and this works, with or without the CM19 attached).
Now, I used to use Case's CM19 USB plugin when I used Homeseer 1.x, along with his web-page interface. That doesn't work under Windows 7 & Homeseer 2.
So, I guess my question is....does anybody know if the CM15 plug-in accepts variables from programming, and if so, what would the syntax of those commands be ?
That being said, the CM15 USB interface DOES transmit signals to the pan & tilt cameras.....however, only through the remote control...but does that not indicate that the CM15 is capable of accepting variables and sending them on the the pan & tilts ? ( Oh, and this works, with or without the CM19 attached).
Now, I used to use Case's CM19 USB plugin when I used Homeseer 1.x, along with his web-page interface. That doesn't work under Windows 7 & Homeseer 2.
So, I guess my question is....does anybody know if the CM15 plug-in accepts variables from programming, and if so, what would the syntax of those commands be ?
Comment