z wave polling

lordmayim · #1 November 24th, 2009, 08:08 PM

i am getting the following log warning when polling devices:

11/24/2009 5:01:08 PM Warning In Set Level for device Z-Wave guest room Guest room light which does not match command type Switch Binary, and its actual device could not be located - cannot continue.

11/24/2009 5:01:08 PM Warning In Set Level for device Z-Wave living room fireplace light which does not match command type Switch Multilevel, and its actual device could not be located - cannot continue.

11/24/2009 5:01:08 PM Warning In Set Level for device Z-Wave living room Tv light which does not match command type Switch Binary, and its actual device could not be located - cannot continue.

11/24/2009 5:01:09 PM Warning In Set Level for device Z-Wave master bedroom master bedroom - me which does not match command type Switch Multilevel, and its actual device could not be located - cannot continue.

11/24/2009 5:01:09 PM Warning In Set Level for device Z-Wave master bedroom master bedroom - her which does not match command type Switch Binary, and its actual device could not be located - cannot continue.

Im not sure what these log entries mean???

any help is appreciated.

Rupp · #2 November 24th, 2009, 08:22 PM

It means that the device isn't registered correctly with HomeSeer. Try re-adding the device so that HomeSeer can pick up the correct attributes on your device.

lordmayim · #3 November 24th, 2009, 08:50 PM

Quote:

Originally Posted by Rupp

It means that the device isn't registered correctly with HomeSeer. Try re-adding the device so that HomeSeer can pick up the correct attributes on your device.

even though it still controls the devices? what causes this problem?