Here is my Way2Call setup.
For those that require behind switch operation and not sure of the wiring.
This is quite usefull in the fact that a single way2call can answer multiple lines / CO trunks, not only that but accessing CO6 connects straight
to the way2call. This is a way that system speed dials or pre-programmed terminal buttons can be used to control HS using recognised digits.
This is not currently working but hope it is fixed in 3.0.0.105.
**** Re above now fixed in test version 3.0.0.107****
Hope this helps someone understand how to wire it up.
Peter
For those that require behind switch operation and not sure of the wiring.
This is quite usefull in the fact that a single way2call can answer multiple lines / CO trunks, not only that but accessing CO6 connects straight
to the way2call. This is a way that system speed dials or pre-programmed terminal buttons can be used to control HS using recognised digits.
This is not currently working but hope it is fixed in 3.0.0.105.
**** Re above now fixed in test version 3.0.0.107****
Hope this helps someone understand how to wire it up.
Peter
Attached Files
Comment