I just installed an Aeotec Multisensor 6 Gen 5. I need to reduce the sensitivity of the motion sensor. According to the manual it says:
"Parameter 4 (1 byte decimal) can be configured through your gateway in case the default settings of your Multisensor are not what you desire. For example, this parameter setting is initially set to 5 which is the maximum sensitivity level. If you set it to 1, the sensitivity will be minimum sensitivity. If set it to 0, the motion sensor will be disabled."
Anyone have any ideas how I so this with this unit?
Sure would appreciate some help.
Thanks
Chuck
"Parameter 4 (1 byte decimal) can be configured through your gateway in case the default settings of your Multisensor are not what you desire. For example, this parameter setting is initially set to 5 which is the maximum sensitivity level. If you set it to 1, the sensitivity will be minimum sensitivity. If set it to 0, the motion sensor will be disabled."
Anyone have any ideas how I so this with this unit?
Sure would appreciate some help.
Thanks
Chuck
Comment