what address is being asked for in the "add a controller at this address:" in the config dialog box of the plug-in?
The rain8net pro is connected to Com10 created by a Sena ls100 serial device server
I have tried address 1 and 2 and 33 - 33 because this is what the config program from wgldesigns seems to like.
Homeseer can't find the controller at any or those addresses.
when I run the config program from wgldesigns it finds the device and reads it. However I have never gotten a response from clicking on "load" in their config program.. should there be a response?
I am a bit overwhelmed by the sena ls100 rain8net pro combination, so don't hesitate to hold my hand, thx
The rain8net pro is connected to Com10 created by a Sena ls100 serial device server
I have tried address 1 and 2 and 33 - 33 because this is what the config program from wgldesigns seems to like.
Homeseer can't find the controller at any or those addresses.
when I run the config program from wgldesigns it finds the device and reads it. However I have never gotten a response from clicking on "load" in their config program.. should there be a response?
I am a bit overwhelmed by the sena ls100 rain8net pro combination, so don't hesitate to hold my hand, thx