Announcement

Collapse
No announcement yet.

Missing Zone

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Missing Zone

    Hi. I'm new to homeseer and was hoping someone can help me. I have a nuvo GC with current firmware. The nuvo system was connected to an ISY via a com port on a bitwise bc4. I was hoping to get this to work with homeseer as well but I could not figure out how to get homeseer to use the BC com port. I then purchased an ethernet to serial bridge from Homeseer Model LS100). No luck with that. I could now get that to stay connected to the GC from even a computer with Putty. I then just connected a prolific USB to serial right to the homeseer system and things are finally working. Only problem is that I am now missing a zone. It is zone6. This is making scripting things that I want to do really tough.

    I checked the ini file and found that the zone is missing there. I updated and restarted the plugin. No good. I restarted homeseer, no good. I reboot my hometroller. no good.


    Here is the ini file

    [General]
    Zones=5
    Sources=2
    Debug=False
    Keypads=2
    [Zones]
    1=Living Room
    2=Kitchen
    3=Bedroom
    4=Bath
    5=Sophia


    It is showing incorrect number of sources as well but these show up.

    Any help would be great.

    Thanks.


    #2
    Is anyone going to reply to this?

    Just wondering if there is any support for this plugin. I've read that it seems like it's not supported.

    Comment

    Working...
    X