I have a Rain8Net hardwired to Com 3 of my Hometroller [described in the signature below]. Rain8Net is configured as Address 1. Initially after setup, Rain8Net runs fine via either automated events or iphone device control. After a few days, however, the Hometroller will no longer operate the Rain8Net and the log looks like this:
7/26/2012 4:00:00 AM ~!~Event~!~Event Trigger "Irrigation, Drip"
7/26/2012 4:00:00 AM ~!~Device Control~!~Device: Sprinkler Zone 4 Street Drip Beds (]4) ON
7/26/2012 4:00:04 AM ~!~RainRelay8~!~Warning, timed out waiting for response (on/off), is there a controller at address 1?
At 4:00 AM the day before, the event ran just fine and I can't see anything odd in the log during the 24hrs between. I then open the Interface tab, click the Config button for Rain8Net and reset the Address to 1 using the Initial Configuration "Program Controller" button. Once again I am operational for a day or 2 or 3.
I have a similar setup at another home and it works fine. Any ideas???
7/26/2012 4:00:00 AM ~!~Event~!~Event Trigger "Irrigation, Drip"
7/26/2012 4:00:00 AM ~!~Device Control~!~Device: Sprinkler Zone 4 Street Drip Beds (]4) ON
7/26/2012 4:00:04 AM ~!~RainRelay8~!~Warning, timed out waiting for response (on/off), is there a controller at address 1?
At 4:00 AM the day before, the event ran just fine and I can't see anything odd in the log during the 24hrs between. I then open the Interface tab, click the Config button for Rain8Net and reset the Address to 1 using the Initial Configuration "Program Controller" button. Once again I am operational for a day or 2 or 3.
I have a similar setup at another home and it works fine. Any ideas???
Comment