Hi. I'm new to homeseer and was hoping someone can help me. I have a nuvo GC with current firmware. The nuvo system was connected to an ISY via a com port on a bitwise bc4. I was hoping to get this to work with homeseer as well but I could not figure out how to get homeseer to use the BC com port. I then purchased an ethernet to serial bridge from Homeseer Model LS100). No luck with that. I could now get that to stay connected to the GC from even a computer with Putty. I then just connected a prolific USB to serial right to the homeseer system and things are finally working. Only problem is that I am now missing a zone. It is zone6. This is making scripting things that I want to do really tough.
I checked the ini file and found that the zone is missing there. I updated and restarted the plugin. No good. I restarted homeseer, no good. I reboot my hometroller. no good.
Here is the ini file
[General]
Zones=5
Sources=2
Debug=False
Keypads=2
[Zones]
1=Living Room
2=Kitchen
3=Bedroom
4=Bath
5=Sophia
It is showing incorrect number of sources as well but these show up.
Any help would be great.
Thanks.
I checked the ini file and found that the zone is missing there. I updated and restarted the plugin. No good. I restarted homeseer, no good. I reboot my hometroller. no good.
Here is the ini file
[General]
Zones=5
Sources=2
Debug=False
Keypads=2
[Zones]
1=Living Room
2=Kitchen
3=Bedroom
4=Bath
5=Sophia
It is showing incorrect number of sources as well but these show up.
Any help would be great.
Thanks.
Comment