As a toe in the water I have recently installed a PLCBus PC interface (PLCBUS-1141) and a lamp module (PLCBUS-2026U) with the PLCBus Connector.
After setting up and registering the lamp module I set the lamp to ON (100%) in HS but the lamp came on dimmed to about 25%. Using HS I ramped the dim level to 95% which woked. I then switched the lamp OFF but when I switched the lamp back on it goes to 25% again.
Any ideas?
After setting up and registering the lamp module I set the lamp to ON (100%) in HS but the lamp came on dimmed to about 25%. Using HS I ramped the dim level to 95% which woked. I then switched the lamp OFF but when I switched the lamp back on it goes to 25% again.
Any ideas?
Comment